10,000 kg Grease Tank / Dispensing Solution

Report Date: April 2022

Back to Projects

In early 2022 GOSS Engineering (Formally known as Integrated Reliability Solutions as pictured below) was commissioned by a mining client to design, build & commission a custom 10,000kg Grease Tank & Dispensing Solution.

  1. 10,000kg capacity
  2. 28kg Flow Rate
  3. Follower plate
  4. Overfill protection
  5. Heater – Thermostat controlled
  6. Load Cells – Sim Card for data transfer
  7. Internal pressure relief
  8. Side mounted level gauge
  9. Auto Pressure Vent
  10. Fill and discharge grease filtration at 200µ

The discharge end consisted of:

  1. 26:1 Grease pump
  2. Pressure relief valve
  3. Pressure venting valve
  4. Air service units
  5. Discharge grease filter
Contact Us About This Project

The grease fill point incorporated the fill filter and overfill shut-off valve.

The system is fitted with a sim card for real data monitoring and transfer back to the control room and the supplier.

Load Cell control and communications system.

Load cells and thermostatic controlled grease heater

A very difficult lift for the Wilsons Cranes boys. Its reassuring to watch their expertise come to the fore when getting a high lift through our workshop low roller door.